This AIRCRAFT ORDNANCE SYSTEMS MECHANIC position is located in the Egress Systems Shop of the Aerospace Systems Section, Field Maintenance Branch, Aircraft Maintenance Division and is part of the CA 144 FW.

Duties

THIS IS A T32 EXCEPTED SERVICE, PERMANENT POSITION The primary purpose of the AIRCRAFT ORDNANCE SYSTEMS MECHANIC, WG-6652-8/10, is to perform on and off equipment maintenance on aircraft egress systems, such as aircraft ejection seats, extraction and escape systems, egress components of jettison canopies, explosive components of escape hatches and doors, and egress trainers.

Requirements

Qualifications

General Experience: Possess experience or training which demonstrates the applicant's ability to repair malfunctions of ordnance equipment and components; Ability to use sketches, electrical diagrams, technical specifications and engineering drawings; Experience which demonstrates skill in the use of test equipment to make electrical, hydraulic, and pneumatic checks. AIRCRAFT ORDNANCE SYSTEMS MECHANIC, WG-6652-08: Must havehave 12 months experience or training in repair and installation of ordnance equipment and components such as launchers, pylons, bomb racks and actuators; Experience which required the ability to diagnose malfunctions; Experience in hand tools and a limited number of measuring instruments; Experience in the use of a variety of test equipment; Experience interpreting and applying a variety of technical manuals and similar published materials. AIRCRAFT ORDNANCE SYSTEMS MECHANIC, WG-6652-8/10: Must have 18 months experience or training in planning and layout of repair sequence and ability to complete modification, repair and installation of ordnance systems; Experience in diagnosing and troubleshooting malfunctions and determining remedy where complex relationships exist; Experience in hand tools and a limited number of measuring equipment; Experience in the use of a variety of test equipment; Experience in interpreting technical directions, blueprints, sketches, wiring diagrams and manufacturer's specifications. TRAINEE POSITION: Applicants not meeting full qualifications for the WG-10 position indicated above may be considered for WG-08 trainee, if qualified. Statement-of-Difference of qualification requirements for each are indicated. If appointed as trainee, the selectee may be non-competitively promoted to WG-10 upon meeting full qualifications and recommendations of supervisor. Your qualifications will be evaluated on the following competencies: Ability to InspectAbility to Provide Production Support ServicesAbility to Use Prints and DrawingsTroubleshooting

Education

N/A

Contacts

• Address CA 144 FW 144th Fresno, CA 93727 US
• Name: For More Information
• Phone: (000) 000-0000
• Email: [email protected]