This position is located in the Facilities Services Directorate (FSD), Washington Headquarters Services (WHS) under the Assistant Director of Engineering and Construction Management (ECM), Engineering/Architecture Division (EAD). The Facilities Services Directorate is responsible for the management (including establishing policies, standards and procedures), administration and operation of facilities and services used by the Department of Defense in the National Capital Region (NCR).

Duties

Incumbent typical work assignments may include the following: Works with the CMD, other senior DoD managers and higher graded engineers on general engineering issues that pertain to construction at the Pentagon, RRMC and the NCR. Assists in preparing cost estimates and similar information that supports proposed new construction or renovation projects. Performs independently analytical assignments of moderate difficulty in assisting in investigations of engineering systems that are not operating properly or have reached capacity based on the original design or life-cycle. Assists Contracting Officer Representatives (CORs) responsible for the technical administration of designated contracts.

Requirements

• U.S. Citizenship is required
• Males born after 12-31-59 must be registered or exempt from Selective Service (see https://www.sss.gov/Home/Registration)
• May be required to successfully complete a probationary/trial period
• Must be determined suitable for federal employment
• Required to participate in the direct deposit program
• This position is subject to pre-employment and random drug testing
• The incumbent must obtain and maintain a Top Secret Security Clearance.
• The incumbent must obtain the Project Management Professional (PMP) Certification from the Project Management Institute, or an approved equivalent certification, within 2 years from the date of employment.
• A professional engineer license in any state, the District of Columbia, Guam or Puerto Rico is preferred for this position.
• DAU Contracting Officer Representative (COR) certification is preferred.

Qualifications

For qualifications determinations, it is recommended that applicants include their months and hours worked per week for each employment listed on their resume. If a determination is not able to be made about the length of your creditable experience for qualification requirements, you will be removed from consideration. Read more about what should I include in my federal resume? at https://www.usajobs.gov/Help/faq/application/documents/resume/what-to-include/ Basic Requirements: A. Degree: Engineering. To be acceptable, the program must: (1) lead to a bachelor's degree in a school of engineering with at least one program accredited by ABET; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics. OR B. Combination of education and experience -- college-level education, training, and/or technical experience that furnished (1) a thorough knowledge of the physical and mathematical sciences underlying engineering, and (2) a good understanding, both theoretical and practical, of the engineering sciences and techniques and their applications to one of the branches of engineering. The adequacy of such background must be demonstrated by one of the following: 1. Professional registration or licensure -- Current registration as an Engineer Intern (EI), Engineer in Training (EIT)1, or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration. For example, an applicant who attains registration through a State Board's eminence provision as a manufacturing engineer typically would be rated eligible only for manufacturing engineering positions. 2. Written Test -- Evidence of having successfully passed the Fundamentals of Engineering (FE)2 examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico. 3. Specified academic courses -- Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and that included the courses specified in the basic requirements under paragraph A. The courses must be fully acceptable toward meeting the requirements of an engineering program as described in paragraph A. 4. Related curriculum -- Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelor's degree in engineering, provided the applicant has had at least 1 year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions. (The above examples of related curricula are not all inclusive.) You may qualify at the GS-14 level, if you fulfill the following qualification requirement: One year of specialized experience equivalent to the GS-13 grade level in the Federal service (experience may have been gained in the private sector) that demonstrates your ability in at least two of the following four engineering branches: Special Civil, Mechanical, Electrical, or Building (Architectural) Engineering. * The Civil Engineering (CE) expertise may be in (1) Structural Engineering, (2) Geotechnical Engineering, or (3) Civil and Site Engineering, (4) Road or Bridge Engineering. * Architectural (Building) Engineering (AE) expertise to be in bridging the technical gap between architects and engineers (civil, electrical, and mechanical) in building design and construction. * The Mechanical Engineering (ME) expertise must be in (1) Power Plant Engineering (energy efficiency, energy services, facility management, plant engineering, environmental compliance and alternative energy technologies), and (2) Thermal (HVAC Systems). * The Electrical Engineering (EE) expertise must be in (1) Power Engineering (generation, transmission, and distribution of electricity and design of devises such as transformers, electric motors and generator, and power electronics, (2) Building electrical systems for buildings and campuses. ACTIVE DUTY SERVICE MEMBERS: The VOW Act Chapter 21 of Title 5, United States Code (U.S.C.), Section 2108a, requires Federal agencies treat active duty service member as veterans, disabled veterans, and preference eligible, when they submit, at the time they apply for a Federal job, a "certification" of active service in lieu of a DD-214, assuming the service member is otherwise eligible. A "certification" letter should be on letterhead of the appropriate military branch of the service and contain (1) the military service dates including the expected discharge or release date; and (2) the character of service. The service member's military service dates are necessary in order to determine whether he or she meets the definition of "veteran" under 5 U.S.C. 2108(1). The "certification" must reflect the service member is expected to be discharged or released from active duty service in the armed forces under honorable conditions not later than 120 days after the date of submission. The "certification" must be signed by, or by direction of, the adjutant, personnel officer, or commander of your unit or higher headquarters and must indicate when your terminal leave will begin (if applicable), your rank, dates of active duty service, the type of discharge and character of service (i.e. honorable). Further, under paragraph (h) of the rule, agencies are required to verify a qualifying separation from military service prior to appointment, through the DD-214 or other appropriate documentation. Your preference and/or appointment eligibility will be verified prior to appointment. Active duty members that fail to provide a valid "certification" of service with their initial application will be found "not eligible." Current or Former Political Appointees: Beginning January 1, 2010, agencies must seek prior approval from OPM before they can appoint a current or recent political appointee to a competitive or non-political excepted service position at any level under the provisions of title 5, United States Code. If you are currently or have been within the last 5 years, a political Schedule A, Schedule C, or Non-career SES employee in the executive branch, you MUST disclose that to the Human Resources Office. Submit a copy of your applicable SF-50, along with a statement that provides the following information regarding your most recent political appointment: Position title; Type of appointment (Schedule A, Schedule C, Non-career SES, or Presidential Appointee); Agency; and, Beginning and ending dates of appointment. All qualifications, education, and time-in-grade requirements must be met by the closing date of this announcement and clearly documented in your resume.

Education

ARE YOU USING YOUR EDUCATION TO QUALIFY? You MUST provide transcripts to support your educational claims. Education must be accredited by an accrediting institution recognized by the U.S. Department of Education. Unless otherwise stated: (1) official or unofficial transcripts are acceptable, or (2) you may submit a list with all of your courses, grades, semester, year, and credit for the course. All materials must be submitted by the closing date of the announcement.

PASS/FAIL COURSES: If more than 10 percent of your undergraduate course work (credit hours) were taken on a pass/fail basis, your claim of superior academic achievement must be based upon class standing or membership in an honor society.

GRADUATE EDUCATION: One academic year of graduate education is considered to be the number of credits hours your graduate school has determined to represent one academic year of full-time study. Such study may have been performed on a full-time or part-time basis. If you cannot obtain your graduate school's definition of one year of graduate study, 18 semester hours (or 27 quarter hours) should be considered as satisfying the requirement for one year of full-time graduate study.

ARE YOU QUALIFYING BASED ON EDUCATION or A COMBINATION OF EDUCATION AND EXPERIENCE?
You must provide sufficient documentation of your education in your resume. You are strongly encouraged to provide a copy of transcripts or degrees in your application package. It is also acceptable to document your applicable course listing in your resume (course number, credits earned, etc.). Education must be accredited by an accrediting institution recognized by the U.S. Department of Education in order for it to be credited towards qualifications. Therefore, provide only the attendance and/or degrees from schools accredited by accrediting institutions recognized by the U.S. Department of Education. Applicants can verify accreditation at the following website: http://www.ed.gov/admins/finaid/accred/index.html. All education claimed by applicants will be verified by the appointing agency. If selected, an official/sealed transcript will be required prior to appointment.

FOREIGN EDUCATION: If you are using education completed in foreign colleges or universities to meet the qualification requirements, you must show the education credentials have been evaluated by a private organization that specializes in interpretation of foreign education programs and such education has been deemed equivalent to that gained in an accredited U.S. education program; or full credit has been given for the courses at a U.S. accredited college or university. For further information, visit: https://www2.ed.gov/about/offices/list/ous/international/usnei/us/edlite-visitus-forrecog.html

Contacts

• Address WHS Facilities Services Directorate Human Resources Directorate 4800 Mark Center Drive Alexandria, VA 22350 US
• Name: Washington HQ Services
• Email: [email protected]