You will serve as a OILER in the Repair Department, of TRIDENT REFIT FACILITY, BANGOR.

Duties

You will take oil samples of equipment to determine in they need change. You will dispose of all waster generated using proper waste information sheets, appropriate containers, and established procedures You will disassemble resin filter canisters. You will energize and operate equipment to move parts to check fluid levels. You will disassemble and reassemble equipment for fluid and filter changes. You will replace coolant lines, hoses, fittings, and pumps. You will perform routine maintenance operations such as: cleaning and flushing bearings and gear boxes, replacing defective oil lines, cups, grease retainers and fittings, and tightening pump glands. You will disassemble and reassemble equipment to accomplish fluid and filter changes, and repair and replacement of coolant lines, hoses, fittings, and pumps. You will use appropriate testing instruments and procedures to check coolant and lubricant for cleanliness, proper ratios.

Requirements

• Must be a US Citizen.
• Must be determined suitable for federal employment.
• Must participate in the direct deposit pay program.
• New employees to the Department of the Navy will be required to successfully pass the E-Verify employment verification check. To learn more about E-Verify, including your rights and responsibilities, visit e-verify.gov
• Within the Department of Defense (DoD), the appointment of retired military members within 180 days immediately following retirement date to a civilian position is subject to the provisions of 5 United States Code 3326.
• Males born after 12-31-59 must be registered for Selective Service.
• This is a bargaining unit position.
• You will be required to successfully complete a pre-appointment physical examination.
• You will be required to obtain and maintain an interim and/or final security clearance prior to entrance on duty. Failure to obtain and maintain the required level of clearance may result in the withdrawal of a job offer or removal
• This position may require travel from normal duty station to CONUS and OCONUS and may include remote or isolated sites. You must be able to travel on military and commercial aircraft for extended periods of time

Qualifications

Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out element which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on the screen-out element(s) will be found ineligible. The Screen-out Element for this position is: ABILITY TO DO THE WORK OF THE POSITION WITHOUT MORE THAN NORMAL SUPERVISION. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification Handbook for Trades and Labor Occupations. Additional qualification information can be found at: https://www.opm.gov/policy-data-oversight/classification-qualifications/federal-wage-system-qualifications/#url=List-of-Approved-Job-Elements Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment.

Education

This job does not have an education qualification requirement.

Contacts

• Address TRIDENT REFIT FACILITY, BANGOR 7000 Finback Circle Silverdale, WA 98315 US
• Name: Department of Navy EIC
• Email: [email protected]